A Complete Information on Surface Mount Technology Due to increasing uses of
various types of devices, they are more or less aware of the utilities of
printed circuit boards that are extremely valuable for the devices. Most of the
modern devices work with various types of PCBs which either have through-hole
components or components with wire holes and leads in the circuit boards. As
this method is older by existence, it is giving way to newer technology that
evidently is better than the older one. This new methods is known as surface
mount technology which is quite reliable for most of the users. This technology
has improved the appearance as well as performance of the PCB.
SMT, the
acronym of surface mount technology, has been an accepted technology that puts
the electronic components together and helps in fixing them directly into the
PCBs. The technology behind the uses of these mount boards is very much
dependable. It encourages in the making smaller PCB for smaller components. The
size of the board is seriously maintained here HDI 10 layer PCB. For
example, you can take the older mobile phone and compare them with the ones
available today. The older handsets were big, bulky, and heavier but the modern
handsets are smaller and sleek. Both have surface mount boards but their shapes
and sizes are different quite considerably.
The technicians are required
to solder the SMT components and that they can do with the help of two different
techniques or devices. They can use an oven or a soldering iron for fixing the
components with the base board. The task is not difficult at any level but it
requires a greater amount of care and expertise. The use of the soldering iron
is very technical and the user must be very careful about using them. After
soldering the components, the users are needed to do something for protecting
the area so that it does not get damaged. They can do this easily with the help
of PCB soldering mask. This mask is like a pasting that is strong enough to
envelop the entire area where they are pasted.
This new method of using
surface mount technology has a few advantages over the older methods. Accuracy
in positioning the boards is the most important thing that everyone must be very
careful about. They can fix the components on both side of the circuit board. It
can reduce the cost of the manufacturing along with reducing the sized of the
board and the entire setting. However, it is good to know and understand the
cost of this new method is slightly more than that the older methods. It is
mainly because of the fact that this method makes use of better products.
As far as the opinion of the experts is concerned, the installation and
maintenance of the older methods is easy and less expensive. Though it is
partially true, the method of surface mount technology have evolved a great deal
and the performance of the component becomes better with this new method. Going
with this new method is far better and that is why most of the users prefer
using this method only.
more...
Rigid flex PCB